Owner Installation Instructions
Dual Gate Controller DCB-05
15
Menu 10.2
PREV
NEXT
EXIT
SET
Timed Travel
PRESS
Motor Wiring
PREV
NEXT
EXIT
SET
Completed?
PRESS
Current Trips
PREV
NEXT
EXIT
SET
Are Disabled OK?
PRESS
Selecting timed travel setup
Confi rming wiring is completed
Confi rming Obstruction detection is disabled
SET=Drive Motors
PREV
NEXT
EXIT
SET
EXIT=Enter times
Selecting install method
20
fi g
22
fi g
21
fi g
23
fi g
This section shows how to set the travel times when
using drive units with slip clutches etc. Two methods are
available for setting up the travel times. The fi rst allows
the installer to drive the motor(s) so that the actual
travel time can be recorded. The second allows exact
times to be entered. Note: The limit setting procedure
can be aborted at any time by pressing EXIT.
Step 1. Navigating To “Timed Travel Menu”
To navigate to the Menu 10.2 from the main screen
simply press PREV, SET then NEXT. Press SET to start
the setup
Fig. 20
.
Step 2. Confi rming Ready To Start
The Dual Gate Controller will prompt you to confi rm
that the motor wiring is complete. Press SET to continue
Fig. 21
.
The controller will now prompt you to confi rm that you
understand that no current trip obstruction detection
is available when using timed travel. Press SET if you
accept this
Fig. 22
.
Step 3. Selecting The Number Of Motors
The controller will now prompt for the number of
motors to be entered. Use the UP or DOWN key to
select the correct number and then press SET
Fig. 23
.
Step 4. Selecting Setup Method
The controller will now prompt for the setup procedure
to be selected. Press SET to set the travel times by
actually driving the motor(s) or press EXIT to enter
Timed travel setup
