44
17
DOES ALTERNATOR
HAVE A
REMOTE SENSE?
'N' OR 'Y'
See photo of non remote sense
alternator alternator below “N” for
Non-remote sense alternator
STANDARD ALTERNATOR OUTPUT TEST (Cont.)
DOES VEHICLE HAVE
J-1708 DATA PORT?
'N' OR 'Y'
If vehicle is equipped with a J-1708
port and you have the optional
cable. Select “Y”. If vehicle is not
equipped with J-1708 data port or
you don’t have an optional J-1708
cable select “N”
If NO skip the next two steps.
>ATTACH J-1708
DATA CABLE
'N' TO CANCEL
Attach the cable from the tester to
the data port on the vehicle.
NOTE: if the tester does not detect it
is hooked to the data port it will not
go beyond this screen.
TURN IGNITION
SWITCH ON
Once it detects it is hooked up
properly it will prompt you to turn
the ignition key to the run position.
Non Remote Sense (empty port)
Non Remote Sense Alternator
ALTERNATOR BENCH TESTING (Cont.)
TURN MOTOR SWITCH
OFF.
'Y' TO CONTINUE.
TURN BATTERY
SWITCH OFF.
'N' TO CANCEL
TURN BENCH POWER
SWITCH OFF.
'Y' TO CONTINUE
#45 12V BENCH
GOOD ALTERNATOR
GOOD REG. 14.47V
After the BCT-200J has tested the
alternator it will prompt for the motor,
the battery switch and the bench power
to be turned off.
After the bench is turned off the
BCT-200J will report the condition
of the alternator.
ALLOWING VOLTAGE
TO STABILIZE
14.47V.
PLEASE WAIT . . .
VERIFY THAT BELT
IS AROUND LARGE
PULLEY.
'Y' TO CONTINUE
If this prompt shows up during the
alternator test then verify that the belt
goes around the large pulley on the
bench motor and that the correct pulley
is used on the alternator. If the correct
pulleys are being used then press Y/
Enter to continue otherwise press
N/Cancel and use the correct pulleys.
TESTING
ALTERNATOR
14.47V.
PLEASE WAIT . . .
