10
51
>CONNECT LARGE
LEADS TO THE
BATTERY.
'Y' TO CONTINUE
3
INDIVIDUAL BATTERY TEST
When the test results appear as
GOOD BATTERIES after running
the PM Check or Battery Bank
Test there is no need to run the
individual battery tests. Press (N
Esc.) to return to the menu
Connect the large red clamp to the
positive and the large black to the
negative battery terminal. If the
clamps are connected improperly
you will be prompted to correct
the problem. The tester will then
revert back to the beginning or
main menu. Be sure to use post
adapters on threaded steel posts
as illustrated on the next page
then press (Y Enter).
If the battery bank test results are
low you will be instructed to test
each battery separately. Press (Y
Enter) to continue.
Select BATTERY TEST from the
main menu.
Note!
When testing batteries individually each battery should be
disconnected. Avoid improper results and damage to the posts by using
the included post adapters on threaded post batteries.
Always check for dirt and cracks or
leaks in the battery.
Poor connections may be the
reason for battery bank failure.
Clean posts and connections are
essential when checking each
battery. Make sure batteries not
being tested are disconnected.
>INSPECT BATTERY
FOR DIRT, LEAKS
OR CRACKS
'Y' TO CONTINUE
>INSPECT POSTS
AND CONNECTIONS
'Y' TO CONTINUE
#211 12V BANK
GOOD BATTERIES
12.70V CHRG 100%
11.50V LOADED
#211 12V BANK
TEST SEPARATELY
12.38V CHRG 66%
PM TEST
>BATTERY TEST
BATTERY BANK
VDROP TEST
IMPORTANT
Select the month as 01 to 12
Select the day as 01 to 31
Select the year as 04 to 99
Select the hour as 01 to 12 AM/PM
Select the minute as 01 to 60
If you select Yes you can change
the MONTH, DAY, YEAR, HOUR
and MINUTE.
To require a battery serial number before
each battery test select YES. If YES is
selected then before each battery test
the tester will prompt for a 14 digit alpha-
numeric serial number. This serial number
will be printed near the bottom of the
printout along with the warranty code.
Can delete all test data or one item
at a time.
>SET MONTH:01
USE +/-.
'Y' TO CONTINUE
>SET DAY:02
USE +/-.
'Y' TO CONTINUE
>SET YEAR:03
USE +/-.
'Y' TO CONTINUE
>SET HOUR:10 AM
USE +/-.
'Y' TO CONTINUE
>SET MINUTE:12
USE +/-.
'Y' TO CONTINUE
>CHANGE THE TIME
01/31/03 10:12AM
'N' OR 'Y'
>REQUIRE BATTERY
SERIAL #? NO
USE +/-.
'Y' TO SELECT.
>DELETE STORED
DATA
USE +/-.
'N' OR 'Y'
SETUP (Cont.)
