107
AutoScale
–
taps it to enable automatic set-up of the voltage scale and time base
for the signals received.
Start/Stop
– taps it to turn on/off the scope.
Single
– taps it to activate the Single trigger mode when the trigger is on. The
Single trigger mode configures the trigger to occur once when the scope captures
the first signal waveform by the preset trigger point.
Measurement Grid
The two control features - Voltage per division and Time per division
– enable the users
to adjust the scope settings to suit the particular test measurement.
Figure 16-7
Sample Measurement Grid
Voltage per division
–
shown down the left side of the screen, referred to as the
Y-axis
Time per division
–
shown along the bottom of the screen, referred to as the
X-axis
Multiple Scope Channels
The MaxiScope software features multiple channel display which enables more than
one waveform to be displayed at the same time. It is useful for making comparisons
among different signals. The voltage per division for each channel is adjusted
individually while the time base per division is the same for all channels.
To adjust the voltage scale
1. Tap the specific Y-axis of the corresponding channel to enable scale
adjustment. The selected Y-axis is highlighted with thicker dividing line.
2. Adjust the voltage scale of the selected channel with the typical 2-finger zoom
