AUSA C 400 H, Руководство оператора

Страница: 53 / 118

 General recommendations for driving a forklift truck
Basic information for starting up a forklift truck
Entering and leaving the operator cabin, do not hold or pull the steering wheel to enter
the driver cabin, use the handles provided on the front structure of the overhead guard.
Always place one foot on the tread of the sill to prevent slipping when climbing in or out
(fig. 1) .
Never start or operate any of the controls unless seated on the driver’s seat.
Keep the driver’s cab free of objects and tools. These may move around, block a control
or a pedal, and prevent a manoeuvre or stop the forklift.
Before starting to work with the forklift, clean any oil or fuel spills, clean and remove
grease from hands and the soles of shoes
(fig. 2) . Do not forget to carry out the
operations and daily checks listed in the “General maintenance chart” on this Operator’s
and Safety Manual.
Check the correct position and fastening of all the guards, caps and safety stops.
Check that all the controls are operating correctly.
Check that informative and safety plates on the forklift are clean and in good condition.
If they are not in good condition, replace them.
Wear suitable protective that will protect you in the working environment. This may
include a helmet, ear plugs, protective goggles or reflective clothing
(fig. 3) . Do not
wear loose clothing or jewellery or long hair as these could become entangled in the
controls, in moving parts or edges of the machine and prove dangerous.
If working in an enclosed area make certain there is sufficient ventilation to prevent
excessive build-up of exhaust fumes. Under this conditions always stop this engine
when not in use.
Before starting the forklift be certain to check or test the following items:
- Check for any leaks in the fuel, hydraulic or cooling system.
- Clean any oil or fuel leaks that may exist on the forklift controls or operating area.
- Check tire conditions and pressures.
- Re-tight wheel nuts if necessary.
- Check that all controls are working correctly.
- Check the operator seat belt and its attachments.
Ensure seat belt is properly latched. Inspect carefully the condition of this security
system with special attention to:
- cuts or damages in the belt.
- wear or damages in the metallic parts including the anchorage elements.
- badly functioning of the buckle.
- seams or free points of sewing.
Check brake pedal travel and effectiveness.
Check the following fluid levels:
- Fuel
- Braking fluid
- Hydraulic fluid
- Cooling system fluid
- Engine oil
Check the horn.
Check that lighting and signalling systems are clean and work correctly. If they do
not work check the corresponding fuses and bulbs as shown in
MAINTENANCE
OPERATIONS on this Operator’s and Safety Manual.
Jumping on or off the forklift can cause serious injury. Always face the machine and use
rails and steps to slowly get on and slowly get off the forklift.
Adjust seat position so you are comfortable and can easily reach all the controls. Now
fasten your seat belt.
Always stop the engine and do not smoke when fuelling the machine.
(fig. 4) Follow the
instructions given in the section “Fuel” on this Operator’s and Safety Manual.
C 400 H / C 400 HI / C 400 H x4 / C 400 HI x4
C 500 H / C 500 HI / C 500 H x4 / C 500 HI x4
51
(fig. 4)
(fig. 1)
(fig. 2)
(fig. 3)
Special
Safety
Messages