AUSA C 400 H, Руководство оператора

Страница: 83 / 118

Engine oil: Draining
The oil change should be made when the oil is warm.
WARNING
The engine oil may be very hot. To avoid the risk of burns, do not remove the
drain plug or unscrew the filter if the engine is hot. Wait until the engine oil is
cooler.
- Make sure the forklift is on level ground.
- Remove the dipstick.
- Clean the area around the oil drain hose.
- Place a container below the oil drain hose
(fig. 1) .
- Unscrew the oil drain hose (a) .
- Allow all the oil to drain from the engine.
- Clean the oil drain hose area.
- Screw on the plug and tighten.
Oil filter cartridge: Replacing
The oil filter cartridge (fig. 2)(b) is located on the left-hand side of the engine.
- Unscrew the oil filter cartridge by turning it to the left.
- Clean the base of the filter and oil the seal of the new filter element.
- Screw on the new filter element and tighten it by hand, without using mechanical
means.
Dispose of the used oil filter cartridge in an authorized centre for this purpose.
Engine oil: Filling up
- Remove the dipstick and place a funnel in the opening of the oil filler neck located
above the rocker arm cover.
- Fill the engine to the recommended oil level. See FLUIDS AND LUBRICANTS
CHART (references and capacities) in this Operator’s and Safety Manual for oil
specifications and capacity.
- Start the engine and leave idling for a few minutes. Check the areas around the
oil filter and oil drain plug for leaks.
- Switch off the engine.
C 400 H / C 400 HI / C 400 H x4 / C 400 HI x4
C 500 H / C 500 HI / C 500 H x4 / C 500 HI x4
81
(fig. 2)
b
(fig. 1)
a
Periodic
Maintenance
Operations