Assembly Instruction
KS2 / KS2 T
WIN
N
OTE
N
OTE
I
NSTALLATION
STEP
7
C
:
A
SSEMBLY
FRAME
BRACKET
- D
RIVE
MOUNTED
ON
THE
WINDOW
AT
BOTTOM
05
Route cable on the frame or mullion/transom.
Cable must be protected against damage (shearing-off,
kinking, splitting).
Check swiveling area (see chapter „S
AFETY
C
HECK
AND
P
ERFORMING
TEST
RUN
“)
I
NSTALLATION
STEP
7
C
:
A
SSEMBLY
FRAME
BRACKET
- D
RIVE
MOUNTED
ON
THE
WINDOW
AT
THE
B
OTTOM
230V
24V
Holes above
(strips facing outward)
Holes below
(strips facing inward)
N
OTE
rigid-backed
side of chain
snap into place
Produce drill holes with appropriate cross-section.
For the mounting dimensions please refer to the
above-mentioned hole layout drawings (see chapter
„I
NSTALLATIONSTEP
3 - 5“) or pro
ject-specifi c documents
and drawings).
Fit frame brackets (Kxxx).
Make sure they are parallel to casement edge.
Note the soft run mode at drives with
(see chapter „I
NSTALLATION
STEP
7
A
“).
S12
M5
parallel
Kxxx
Transom
Fxxx
FL
FL
Transom
cable duct glued on
(in addition secured with
countersunk screws against
breaking away)
Kxxx
Transom
FL
Attach drive to the frame brackets.
Insert screws M5
and washers
and tighten.
1
2
AK
Connect control voltage (e.g. using a tester) and move
out the chain approx. 100 mm.
Secure chain in the casement bracket with spring
pin. Insert spring pin from the rigid-backed side of the
chain (label side) and snap into place.
With tandem / triple operation actuate all
drives together.
If necessary, use washers. These are depen-
ding on the type of screws used.