7-8
FLEXNET – FNER Expandable (Modular) Routing Switches – Installation & Operation Manual
CHAPTER 7: FACTORY CONFIGURATION SETTINGS
Figure 34: Options Menu
From this menu, you can select to enable/disable SNMP protocol. LNB power is not available with FNER systems. Settings
under this menu are factory preset and should not be changed.
7.18 SNMP Menu
Option 2 of the Options Menu will load the SNMP Menu shown in Figure 35.
To get to the SNMP Menu from the main menu: key sequence 2, 1, (factory settings code F1) 3, 2, 2
2. System Options
1. Configuration (factory settings code F1)
3.
Features
2.
Options
2.
SNMP
Figure 35: SNMP Menu
From this menu, you can enable/disable SNMP protocol and set the Trap IP address. For details on SNMP refer to the section
“SNMP” on page 18.
7.18.1 SNMP On/Off
Option 1 of the SNMP Menu will load the SNMP On/Off screen shown in Figure 36.
To get to the SNMP On/Off screen from the main menu: key sequence 2, 1, (factory settings code F1) 3, 2, 2, 1
2. System Options
1. Configuration (factory settings code F1)
3.
Features
2.
Options
2.
SNMP
1.
On/Off
Figure 36: SNMP On/Off
Press F1 to toggle SNMP protocol on and off. F4 exits to the previous menu.
7.18.2 Set SNMP Trap IP
Option 2 of the SNMP Menu will load the Set SNMP Trap IP screen shown in Figure 37.
To get to the SNMP Trap IP screen from the main menu: key sequence 2, (factory settings code F1) 3, 2, 2, 2.
2. System Options
1. Configuration (factory settings code F1)
3.
Features
2.
Options
2.
SNMP
