ATX 22 Type-S, Руководство пользователя

Страница: 68 / 100

OPERATION | 67
TAPS OPERATION
Working in conjunction with the patented Convex V hull, TAPS allows variable-hull
trim capability that dramatically enhances wake characteristics, ride and overall
boat performance . With the push of a button, TAPS instantly modifies the hull’s run-
ning angle for optimum watersport wake enhancement, a smoother ride in rough
water, better fuel economy and increased safety and comfort .
TAPS adjustments are made using the rocker switch located on the throttle
handle . Always keep your left hand on the steering wheel and your right hand
on the throttle .
The location of the TAPS switch allows operation with the right thumb, main-
taining safe, hands-on control of the throttle .
TAPS switch adjustments can be made while stopped or while underway at
any speed . The position of TAPS plate is indicated on the TAPS gauge located top
center of the ATXperience Control Center home screen .
Settings range from 1, a flat, bow-low running angle to 8, a bow-high running
angle . To move the bow to a higher running attitude, push the top of the TAPS
rocker switch (the TAPS will raise) . The TAPS gauge will begin moving toward a
higher number . To lower the bow, push the bottom of the TAPS rocker switch .
The bow angle will lower and the TAPS gauge will move to a lower number .
Although the effects of the various TAPS settings depend on ATX model, passen-
ger load, water conditions, speed and other factors, the following guidelines are
provided as a starting point as you learn to use TAPS to optimize your perfor-
mance needs . Practice and experience using TAPS can also optimize your perfor-
mance needs .
Ride, Safety and Boat Performance
The variable-hull TAPS system also dramatically enhances boat performance,
comfort and safety . To eliminate bow rise on take-off, set TAPS at 1 . As soon as the
boat reaches planing speed, adjust TAPS to 3 or higher, depending on water
conditions . If the water is choppy, less than 6 in . (152 .4 mm) waves, the optimum
ride setting will be from 2 to 5, depending on ATX model and passenger load . If
the water is rougher, 6 to 12 in . (152 .4 to 304 .8 mm) waves, the optimum ride setting
will be from 5 to 8, depending on ATX model and passenger load .
Raising the bow in rougher water will provide a safer, drier ride while maxi-
mizing the hull’s “entry vee” to reduce the effects of the chop . This higher running
attitude will also provide bow passengers with a smoother, drier ride .
To maximize top speed in your ATX, set TAPS between 5 and 8 . When the boat
reaches top speed, bring the TAPS setting down slightly to achieve the optimum
running attitude . Top speed should be achieved at a TAPS setting of 5 to 6 .
TROUBLESHOOTING
No throttle power when you start your boat engine:
Move throttle to neutral and verify that the dash Cruise Control switch
is toggled
OFF .
Boat does not seem to maintain speed on turns or in rough waters:
Verify that you have given your boat plenty of throttle authority (move the
throttle forward) .
For instant planing and clean,
faint slalom wakes . Adjust wake size or trim
for optimum cruising, fuel
efficiency, top speed or
performance .
Convex V hull settles
naturally at boarding and
surfing speeds .