ATLET A-Ergo, Руководство по обслуживанию

Страница: 47 / 250

Se Serrvi vice ce / S / Sp pe eci ciffiic i c ins nstr tru uct ctio ion ns / s / Li Lifft c t cha haiin ns a s an nd f d fo orrks ks 3 3..2 21 1
ATLET SERVICE MANUAL A-ERGO ATLET SERVICE MANUAL A-ERGO
Lift chains and forks Lift chains and forks
Check Check
For safety reasons the forks and all lift For safety reasons the forks and all lift chains should checked during ea chains should checked during each service. ch service.
If a lift If a lift chain fails to be approved in any respect, the complete chain must be replaced; chain fails to be approved in any respect, the complete chain must be replaced;
and it is not permitted to and it is not permitted to replace parts of a lift chain. replace parts of a lift chain.
Important! Important!
If the lift c If the lift chain fails to be approved in any respect the complete chain must be hain fails to be approved in any respect the complete chain must be
replaced. replaced.
See under section 6 See under section 6 for instructions concerning checking chains and forks. for instructions concerning checking chains and forks.
Regular maintenance Regular maintenance
The chain should be kept clean. The chain should be kept clean.
Lubricant (see Lubricant (see “Check list, service inspektion” on page 3.7 “Check list, service inspektion” on page 3.7) must be regularly applied ) must be regularly applied
on on the chain s the chain so that all working su o that all working surfaces are continuously rfaces are continuously lubricated. lubricated.
The chain should be kept in motion when lubricating to ensure that the lubricant The chain should be kept in motion when lubricating to ensure that the lubricant
penetrates the working surfaces between the link plates
penetrates the working surfaces between the link plates and pins. All excess lubricant and pins. All excess lubricant
should wiped off, but solvent must should wiped off, but solvent must not be used. not be used.
If the chain runs dry it If the chain runs dry it should be lubricated more often; this also applies if the should be lubricated more often; this also applies if the truck is truck is
working in special environments such as cold st working in special environments such as cold stores, etc. ores, etc.
Overhead guard Overhead guard
First service First service
1. 1. The at The attach tachment ment betwe between th en the ove e overhead rhead guar guard and c d and chass hassis sh is should ould be ret be retighte ightened ned
during the first service. during the first service.
2. 2. The ti The tighte ghtening ning torqu torque be e between tween the o the overh verhead ead guard guard and and chass chassis sho is should uld be be 81 Nm. 81 Nm.
Forks and lift Forks and lift
chains should
chains should
be checked
be checked
during each
during each
service service
e e g g e en n n ng g
after 200 hour after 200 hour s s
Tightening Tightening
torque:
torque:
81 Nm 81 Nm
https://www.besttruckmanuals.com/