ATLET A-Ergo, Руководство по обслуживанию

Страница: 108 / 250

ATLET SERVICE MANUAL A-ERGO ATLET SERVICE MANUAL A-ERGO
6. 6.30 30 Ma Mast st sy syst stem / em / Re Repa paiir i r ins nstr truc ucttiion ons / s / Fo Fork rk ca carr rriiag age, e, ttel eles esc cop opic ic fo fork rks, s, T TF F
12. 12. Remov Remove the oute e the outer circlip r circlips holdin s holding the side be g the side bearing for the s aring for the shaft haft, pos. 1 , pos. 16.34 6.34..
13. 13. Loos Loosen the en the inte intermedi rmediate be ate bearing, aring, pos pos. 2 fig . 2 figure ure6.34 6.34. Drive the shaft to one . Drive the shaft to one side so side so
that the side bearing can be pressed out of the fork c that the side bearing can be pressed out of the fork carriage. Remove the bearing arriage. Remove the bearing
and lift the shaft out and lift the shaft out from the fork carriage. from the fork carriage.
14. 14. Note the or Note the order in whic der in which the gear h the gear, circlip , circlips and spa s and spacers are fit cers are fitted, an ted, and then work d then work
them off. them off.
Assembling the fork carriage TF Assembling the fork carriage TF
1. 1. Fit the Fit the spro sprockets ckets in the in the tips of t tips of the inn he inner for er forks. Li ks. Lightly g ghtly grease rease the be the bearing aring inside inside and and
outside before fitting. outside before fitting.
2. 2. Fit th Fit the rear e rear shaf shaft with s t with sproc procket, ket, stop ri stop rings a ngs and b nd bearin earing hou g housing sing. Ch . Check th eck that th at thee
shaft is not tensioned skew by rotating it by shaft is not tensioned skew by rotating it by hand at least one turn in each direction. hand at least one turn in each direction.
3. 3. Fit an Fit and ad d adjust th just the fork e fork chains chains so tha so that they t they run p run paralle arallel with th l with the spr e sprocke ockets, an ts, and so d so
that they give 2-4 mm in that they give 2-4 mm in the middle. Lock the sprockets, stop rings and chain the middle. Lock the sprockets, stop rings and chain
tensioners. Lightly grease the chains along their tensioners. Lightly grease the chains along their entire length. entire length.
4. 4. Fi Fit t t the he ov over er-c -cog oggi ging ng gu guar ard. d.
Figure 6.34 Figure 6.34 Outer circlips for side bearing and intermediate bearing Outer circlips for side bearing and intermediate bearing
06_016-6_A-Ergo_ TFgafflar.eps 06_016-6_A-Ergo_ TFgafflar.eps
2 2
1 1
97 97
https://www.besttruckmanuals.com/