Atlas Triton T-80, Руководство по эксплуатации

Страница: 32 / 48

F 30
F. TROUBLESHOOTING
F.1. C
ONTROLLER LOCKOUT AND HOLD CODES
.
!
NOTE:
To support the recommended Troubleshooting, the Hon-
eywell SOLA controller has an Alert File. Review the Alert
history for possible trends that may have been occurring
prior to the actual Lockout.
Note Column: H= Hold message; L=Lockout message;
H or L= either Hold or Lockout depending on Parameter
Con guration
Code Description
Recommended Troubleshooting of Lockout
Codes
Note
Safety Data Faults
1 Uncon gured safety data 1. New Device, complete device con guration and safety
veri cation.
2. If fault repeats, replace module.
L
2 Waiting for safety data veri cation 1. Device in Con guration mode and safety parameters need
veri cation and a device needs reset to complete veri cation.
2. Con guration ended without veri cation, re enter con gura-
tion, verify safety parameters and reset device to complete
veri cation.
3. If fault repeats, replace module.
L
Internal Operation Errors
3 Internal fault: Hardware fault
Internal Fault.
1. Reset
Module.
2. f fault repeats, replace module.
H
4 Internal fault: Safety Relay key feedback error H
5 Internal fault: Unstable power (DCDC) output H
6 Internal fault: Invalid processor clock H
7 Internal fault: Safety relay drive error H
8 nternal fault: Zero crossing not detected H
9 Internal fault: Flame bias out of range H
10 Internal fault: Invalid Burner control state H
11 Internal fault: Invalid Burner control state ag H
12 Internal fault: Safety relay drive cap short H
13 Internal fault: PII shorted to ILK H or L
14 Internal fault: HFS shorted to LCI H or L
15 Internal fault: Safety relay test failed due to feedback ON L
16 Internal fault: Safety relay test failed due to
safety relay OFF
L
17 Internal fault: Safety relay test failed due to
safety relay not OFF
L
18 Internal fault: Safety relay test failed due to
feedback not ON
L
19 Internal fault: Safety RAM write
Internal Fault.
1. Reset
Module.
2. f fault repeats, replace module.
L
20 Internal fault: Flame ripple and over ow H
21 Internal fault: Flame number of sample
mismatch
H
22 Internal fault: Flame bias out of range H
23 Internal fault: Bias changed since heating cycle starts H
24 Internal fault: Spark voltage stuck low or high H
25 Internal fault: Spark voltage changed too much during ame
sensing time
H