C 10
age that the unit receives while in shipping. As
each shipping company has its own procedure for
ling a claim, please contact the shipper for claim
instructions.
C.1.a. Model Identifi cation
•
Your Atlas™ Triton Series™ Boiler carries two identi -
cation plates. The coil identi cation plate, which carries
the ASME Code Stamping and Registration Number
(when applicable), is attached to the water inlet, with a
duplicate on the heat exchanger top plate. The unit’s
nameplate is located on the right side of the rear panel
of the unit, and lists information concerning the input
and output of the unit, electrical and gas ratings, work-
ing pressure and clearance to adjacent construction
gures. In addition, the model and serial numbers are
on the plate. You will need these to order replacement
parts from the manufacturing representative in your
area or from the factory.
•
The information on the National Board plate is the
same as on the nameplate with the exception of the
National Board registration number, which is required in
most states for installation of the unit.
C.1.b. The Boiler Name Plate
The following illustration is an accurate depiction of the
nameplate found on the rear side of the boiler. You will also
nd an ASME nameplate on the inlet pipe with some of the
same information.
FOR EITHER INDOOR OR OUTDOOR INSTALLATION.
NOT FOR INSTALLATION ON COMBUSTIBLE FLOORING.
DISCRIPTION
MODEL NO.
SERIAL NO.
MIN. RELIEF VALVE CAP.
MAX. BTU. /HR. INPUT
MIN. BTU. /HR. INPUT
BTU. /HR. OUTPUT
BTU. /HR. OUTPUT
H.P.
HEATING SURFACE
GROSS E.D.R.
M.A.W.P.
VOLTS
HERTZ
PH.
AMPS.
MOT. AMPS. CTRL. VOLT CTRL. AMP
MIN. GAS PRESS.
MAX. GAS PRESS.
MANIFOLD PRESS.
FUEL TYPE
#2 OIL
IF OIL FIRED, DO NOT USE
OIL HEAVIER THAN #2
INTEGRAL GROUP
PRIMARY SAFETY
MINIMUM CLEARANCES TO
ADJACENT CONSTRUCTION
2701 S. HARBOR BLVD. SANTA ANA, CA 92704
714.437.9050 FAX 714.437.9060
AJAX BOILER INC.
AJAX BOILER INC.
Since 1919
9900456
ETL LISTED
CONFORMS TO
UL STD 795
CERTIFIED TO
CAN STD 1-3.1
!
NOTE:
•
Minimum Btu/Hr. ratings apply to high-low and modu-
lating type boilers only.
•
Boiler output ratings are based on factory tests under
appropriate conditions. Field results may vary.
•
Maximum allowable working pressure for the boiler
relief valve set pressure should not exceed the lowest
MAWP of any component in your system.
•
Applies to forced draft type burners only.
•
Minimum and maximum gas pressure values are
measured at the point of connection to the boiler gas
train. Manifold gas pressures are measured after the
gas train.
!
WARNING:
Do not remove any of these plates from the unit for any
reason. Removal of these plates will void the warranty.
C.1.c The Boiler Model Number
ATLAS T 150 P - W
Brand:
• ATLAS
Boiler Type:
• T
= Triton Series
Firing Rate:
080
= 800,000 Btu/Hr
150
= 1,500,000 Btu/Hr
100
= 1,000,000 Btu/Hr
200
= 2,000,000 Btu/Hr
Fuel Type:
• G
= Natural Gas
• P
= Propane
Cabinet Application:
• W
= Outdoor
•
(No Suf x refers to Indoor Jacketing)
C.2. R
ATING AND
C
ERTIFICATIONS
•
All units must be installed in accordance with all state
and local codes, and national codes, including but not
limited to:
•
ANSI Z223.1/ NFPA 54, National Fuel Code
•
ANSI/ NFPA 70, National Electric Code
•
All Atlas™ Boilers are National Board approved and
designed–certi ed and tested by Intertek (E.T.L.),
standards for the US and Canada (Can Std 1-3.1), and
Ace Heating Solutions, LLC
Содержание Triton T-80
