Atek HP 8753D, Руководство пользователя, Страница: 578 / 677

ASCII: MISSING 'BEGIN' STATEMENT
Error Number
193
The citile you just downloaded over the HP-IB or via disk was not properly
organized. The analyzer is unable to read the \BEGIN" statement.
ASCII: MISSING 'CITIFILE' STATEMENT
Error Number
194
The citile you just downloaded over the HP-IB or via disk was not properly
organized. The analyzer is unable to read the \CITIFILE" statement.
ASCII: MISSING 'DATA' STATEMENT
Error Number
195
The citile you just downloaded over the HP-IB or via disk was not properly
organized. The analyzer is unable to read the \D A T A" statement.
ASCII: MISSING 'VAR' STATEMENT
Error Number
196
The citile you just downloaded over the HP-IB or via disk was not properly
organized. The analyzer is unable to read the \V AR" statement.
AVERAGING INVALID ON NON-RATIO MEASURE
Error Number
13
Y ou cannot use sweep-to-sweep averaging in single-input measurements .
Sweep-sweep averaging is valid only for ratioed measurements (A/R, B/R, A/B ,
and S-parameters). Y ou can use noise reduction techniques , such as narrower
IF bandwidth, for single input measurements .
BAD FREQ FOR HARMONIC OR FREQ OFFSET
Error Number
181
Y ou turned on time domain or recalled a calibration that resulted in start and
stop frequencies that are beyond the allowable limits .
BATTERY FAILED. STATE MEMORY CLEARED
Error Number
183
The battery protection of the non-volatile CMOS memory has failed. The CMOS
memory has been cleared. Refer to the HP 8753D Network Analyzer Service
Guide for battery replacement instructions . See Chapter 12, \Preset State and
Memory Allocation," for more information about the CMOS memory .
Error Messages 10-3