ASV SC50 Scout, Руководство по обслуживанию и ремонту

Страница: 68 / 111

Pilot Generation Block
Removal
1. Relax any hydraulic actuators to relieve pressure
within the hydraulic system.
2. Turn the ignition switch to the OFF position and
remove the key to avoid accidental start.
3. Remove the belly pans beneath the engine and
reservoir.
4. Drain the hydraulic fluid from the machine as
described on page 4-8 of this manual.
5. Disconnect the tubes attached to the “T” fitting on
the top of the pilot generation block. These nuts
are difficult to reach and a crows foot attached to a
ratchet may be helpful in disconnecting these
tubes. (fig. 10-27)
6. Disconnect the hose from the lower 90° fitting as
shown. (fig. 10-28)
7. Disconnect the tube from the forward fitting on the
pilot generation block as shown. (fig. 10-29)
8. Remove the bolts securing the pilot generation
block to the chassis. (fig. 10-30)
9. Once all hoses and tubes are disconnected, dis-
connect the wire harness from the solenoid and
remove the block from the machine. (fig. 10-31)
Installation
1. To install the pilot generation block, reverse the
removal procedure.
10-7
Rubber Track Utility Vehicle
10. Hydraulic Components
Required Tools
Combination/Socket Wrenches
Crows foot
10-27
10-28
10-29
10-30
10-31
https://tractormanualz.com/