ASV SC50 Scout, Руководство по обслуживанию и ремонту

Страница: 40 / 111

2. Reach through from the front of the machine and
squeeze the top and bottom of each switch as
close to the dash as possible to release the clips
that secure them, then push them through dash
slightly as shown. Unplug the connectors as nec-
essary, then remove the switches (fig. 6-7)
3. If necessary, remove the other switches in this
same manner.
Note: It is not necessary to remove the front fascia to
remove these switches, however, if you have difficulty
removing them in this time saving manner, it may be
wise to remove the front fascia to access them.
Installation
1. To reinstall the switches into the dash panel,
reverse the removal procedure.
Front Fascia
Removal
1. Remove the front fascia by first removing the
retaining screws securing the perimeter. Then lift
and remove the fascia. (fig. 6-8)
Installation
1. To reinstall, reverse the removal procedure.
Gauges & Hour Meter
Removal
1. Remove the front fascia from the machine to
access the gauges. Locate the retaining nuts and
remove them. (fig. 6-9)
2. Disconnect the gauges from the wiring harness,
then remove them from the dash. (fig. 6-10)
3. To remove the hour meter, remove the two screws
holding it in place, then disconnect it from the
wiring harness and remove as shown. (fig. 6-11)
Installation
1. To reinstall, reverse the removal procedure.
6-3
Rubber Track Utility Vehicle
6. Operator Enclosure
6-7
fascia
6-8
6-9
6-10
6-11
Allen (hex) wrenches
Required Tools
Socket/Combination Wrenches
Required Tools
https://tractormanualz.com/