5.
Loosen the bleeder bolt once again and move the
front 14” wheels and axle as far rearward as possi
ble. It may be necessary to assist in sliding the
wheels rearward by stepping down on the inside of
the track as shown (fig. 4-35).
6.
Grab hold of the track and the outer front 14” wheel,
then pull them off of the undercarriage together,
from the inside to the outside of the machine
(fig. 4-36).
Note:
Keep the 14” wheel center in line with the axle
as much as possible during wheel/track removal to
avoid damaging the inner wheel seal as it passes over
the threads on the axle shaft.
Note:
The outer bearing on the 14” wheel will most
likely fall out of the wheel as you remove it from the
undercarriage. Make sure to remove it or catch it if
possible to keep it clean (fig. 4-37).
7.
Pull the track the rest of the way off of the under
carriage at the rear of the machine (fig. 4-38).
Repeat this procedure if necessary on the other side of
the machine.
4-11
Rubber Track Utility Vehicle
4. Maintenance
4-34
4-35
4-36
4-37
4-38
https://tractormanualz.com/
Содержание SC50 Scout
