ASV SC50 Scout, Руководство по обслуживанию и ремонту

Страница: 63 / 111

1. Relax any hydraulic actuators to relieve pressure
within the hydraulic system.
2. Turn the ignition switch to the OFF position and
remove the key to avoid accidental start.
3. Drain the hydraulic fluid. Refer to page 4-8 for the
hydraulic fluid and filter change procedure.
4. Remove the cargo bed according to the procedure
on page 7-3 of this manual.
5. Remove the belly pan beneath the center of the
machine.
6. Disconnect the inlet tube from the charge/auxiliary
pump as shown. (fig. 10-1)
7. Disconnect the outlet hoses from the auxiliary and
charge pumps as shown. (fig. 10-2, 10-3)
8. Remove the bolts securing the charge/auxiliary
pump to the drive pump, then remove it through
the bottom of the machine as shown. (fig. 10-4)
Installation
1. To install the charge/auxiliary pump, reverse the
removal procedure.
Tandem (Drive) Pump
Removal
1. Remove the engine cover and unfasten and move
the heater (if equipped) from its brackets to access
the drive pump.
2. Remove the charge/auxiliary pump as described
on page 10-1 of this manual.
3. Label the hoses and pump housing as shown or
with your own method to ensure that all hoses are
connected to the proper ports during reinstallation.
(fig. 10-5)
10-2
Rubber Track Utility Vehicle
10. Hydraulic Components
10-1
10-3
10-4
10-2
Required Tools
Combination Wrench
Socket Wrench
Screwdriver (blade type)
10-5
https://tractormanualz.com/