AstroNova TrojanLabel T3-OPX, Руководство пользователя

Страница: 58 / 98

Operation menus
T3-OPX User Guide 58
If the Vacuum unit is installed, this can be left on, as the gas dampers can hold the weight
of the VAC unit.
Press the Remove service tray button and wait for the service tray to retract. Pull out
the service tray and replace it with a fresh tray.
Notice the printhead will be uncapped during this process, so have the replacement tray
ready before starting this process.
Install Service Tray
When the service tray is re-inserted, press Install service tray . The service tray will
move into position and cap the printhead. The Service tray life status should be
99-100% for a new tray.
Go to Print
Pressing this button will uncap and move the printhead into the print position, directly over
the crash plate. Use this function if you suspect that the printhead is not lining up directly
over the crash plate. It is important that the print position is over the crash plate, as this
ensures that the printhead is as close to the media as possible.
Uncap Print Head
This function will retract the service tray and expose the printhead. This can be useful if
you want to manually wipe the printhead. The printhead will be uncapped for 60 seconds
and then automatically capped again.
Important: Only use a clean lint-free cloth and DI water. Wipe gently across the surface.
Cap Print Head
This function will cap the printhead by moving the service tray back in to the idle position.
Calibrate Service Tray
Press Calibrate Service Tray to restore service tray life to 100% (if the service tray is
new).
Important: Use only if the service tray has been replaced with a new one.