Astria Fireplaces Arcadia18MN, Инструкция по установке и эксплуатации

Страница: 12 / 28

www.Astria.US.com
1 26896 -01A 12
OPERATING APPLIANCE
Continued
WARNING: Make sure selec -
tor switch is in to OFF position
when you are away from home
for long periods of time. Appli-
ance will come on automatically
with selector switch in the ON
position.
TO TURN OFF GAS
TO APPLIANCE
Shutting Off the Appliance
1. Turn control knob clockwise to the
OFF position.
2a. Set selector switch in the OFF position.
2b.
If Using Optional Hand-Held Remote:
Set selector switch in the OFF position to
prevent draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burners and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise
to the
PILOT position.
2. Use remote control manual OFF button.
3. Set selector switch in the OFF position.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under Lighting
Instructions , page 16.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11, Lighting Instructions , page 17.
Figure 12 - Pilot (Remote Shown)
Propane/LP Natural
OPTIONAL HAND-HELD
REMOTE CONTROL
OPERATION
1. After lighting, let pilot flame burn for
about one minute. Turn control knob to
ON position. Adjust flame adjustment knob
anywhere between HI and LO. Set toggle
selector switch to AUTO. Slide remote
selector switch to REMOTE position (see
Figure 13). Note: The burner may light if
hand-held remote was on when selector
switch was last turned off. You can now
turn the burner on and off with the hand-
held remote control unit.
IMPORTANT : Do not leave the selector
switch in the REMOTE or ON position
when the pilot is not lit. This will drain the
battery.
2. Press ON/OFF button to turn burners on
and off. When turning burners off, the pilot
will remain lit.
IMPORTANT:
Be sure to press ON/OFF
buttons on hand-held remote control unit for
up to 3 seconds to assure proper operation.
Remote Control Specifications
Batteries
: (See instructions with remote for
removing and installing batteries)
Transmitter requires 12V (A-23) and 3V button
cell for LCD (both included)
Remote receiver requires 4 AA (1.5V) alkaline
batteries (included)
Operating Frequency
: 303.875 MHz
LO
IH
OF
FP
ILO
T
ON
OFF REMOTE ON
AUTO
OFF
ON
Figure 13 - Control Knob and Ignitor
Button Locations for Remote Control
Control Knob
Ignitor
Button
Remote Selector
Switch
Flame
Adjustment
Knob
Selector Switch
in AUTO Position