AsGa LightBolt 28304-E1, Руководство пользователя

Страница: 15 / 100

AsGa Light AsGa Light AsGa Light AsGa LightBOLT BOLT BOLT BOLT 10GigE Switch 10GigE Switch 10GigE Switch 10GigE Switch
U U U User Guide ser Guide ser Guide ser Guide Configuration Configuration Configuration Configuration
15
COMMAND DESCRIPTION
AsGa> enable
To enter in configuration mode ingress the
enable
command
and press enter.
AsGa# service telnet (enable | Disable)
Enable or disable the Telnet Service
AsGa# wr
Save the current configuration
SSH Service:
COMMAND DESCRIPTION
AsGa> enable
To enter in configuration mode ingress the enable
command and press enter.
AsGa# service ssh (enable | disable)
Enable or Disable the SSH Service
AsGa# wr
Save the current configuration
As well to gain access to onboard management agent via a network connection, you must first
configure it with a valid IP address, subnet mask, and route (when it is needed) using a console
connection. The IP address for this switch is unassigned by default; see “
Setting Management IP
address ” on page 22.
This switch supports four concurrent Telnet sessions. After configuring the switch’s IP
parameters, you can access the onboard configuration program from anywhere within the attached
network. The onboard configuration program can beaccessed using Telnet (port 23 by default) or
SSH from any computer attached to the network.
3.13 Configuring the Switch
3.13.1 Basic Configuration – Console Connection
The CLI program provides two different command levels — normal access level (Normal
Exec) or View mode and privileged access level (Privileged Exec) or configuration mode. The
commands available at the Normal Exec level are a limited subset of those available at the Privileged
Exec level and allow you to only display information and use basic utilities. To fully configure the
switch parameters, you must access the CLI at the privileged Exec level. Access to both CLI levels
are controlled by users names and passwords. The switch has no default user name and password
configured.
Connected to the console port to initiate your console connection, just press <Enter>. At the
first time you will not be prompted for a user name and password. You will have the default prompt
name witch will be “AsGa> “ witch indicate the normal Exec mode operation (or View mode).
At this level you can enter at the configuration mode issuing the following commands:
COMMAND
DESCRIPTION
AsGa> Default hostname and prompt will be displayed
AsGa> Enable
To enter in configuration mode ingress the enable command and
press enter.
AsGa#
Now you are into configuration mode or privileged mode.
If you have configured a user name and password you will be prompted: