Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
82
Installation
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
Fitting expansion cards
Expansion cards can be fitted to any expansion slot.
Exception: On the Ascotel® IntelliGate® 2065, the middle slot (No. 8) is reserved for
the MPC-8260 processor card (
).
Procedure:
A Torx screwdriver, size Torx 10, is needed to secure the screening strip (front cover)
to the metal cage.
Hazard:
Be sure to observe the
.
1.
Switch off the PBX: When using a UPS disconnect the battery first, then discon-
nect the PBX and any external Auxiliary Terminal Power Supply (ATPS) from the
230 V mains.
2.
Remove the PBX cover.
3.
Before handling an expansion card, touch the earthed metal cage of the PBX.
4.
Take the expansion card out of the ESD protective sleeve.
5.
Fit the expansion card to the correct slot. Make sure the card is lying in the lower
guide slot of the metal cage and that the ends of the screening strip (front cover)
are flush against the edge of the metal cage once the card has been inserted.
Note:
The maximum torque for screws used for fitting expansion cards and
dummy covers is 0.9 Nm.
6.
Screw the screening strip to the metal cage using the 2 screws supplied.
7.
Fit dummy covers to any empty slots remaining.
Note:
The dummy covers must be fitted to ensure EMC.
8.
Fit the PBX cover.
9.
Connect the PBX and any ATPS system to the 230 V mains, then connect the UPS
battery where applicable.
10.
Keep the ESD protective sleeve in a safe place.
