TD 92816EN
17-July 2012 / Ver. B
8
Programming and Installation Manual
Care Phone
2.1
Programming
The Care Phone must be programmed before it can be installed with the care
recipient. To program the Care Phone, follow the instructions in section 5.1.
2.2
Connection to power supply
The mains adapter is plugged into an ordinary electrical socket and to the socket
on the back of the Care Phone marked 12V (see image 3 below). Then, turn on
the switch (push button marked 0 / 1 to 1).
Note:
Analog Care Phone / GSM Care Phone may only be used with the supplied mains
adapter.
2.3
Connection to the analogue telephone network
Connect the telephone cable into the supplied telephone adaptor and to the
Care Phone in the socket closest to the on/off button (see Image 3 below). The
regular telephone plug should be connected to the supplied telephone adaptor
and then connected to the primary telephone socket at home.
Note:
It is important that the Care Phone is connected to the primary socket (the main
socket) in the home in order to achieve complete security! If you do not do this, your Care
Phone may not be able to call the alarm recipient, for example, if you have another phone
in the home that is not on the receiver. To check which the primary socket is, lift all the
handsets off the receivers in the home. The handset which still has a dial tone is the
primary. If more than one handset has the dialling tone at the same time, the phone
socket is not connected properly and must be adjusted by an authorised installer.
The following illustration shows which jack the telephone cable (white) and
mains adapter (black) are to be connected:
Image 3. Telephone cable and power cable connections
