TD 92816EN
17-July 2012 / Ver. B
35
Programming and Installation Manual
Care Phone
Lost test alarm
If the alarm transmitter has not sent its test alarm as per the test alarm routine,
the Care Phone sends a link test alarm to the alarm receiver. Since more than one
alarm transmitter can be programmed to the Care Phone, the failed test alarms
have been numbered.
Note:
This function must be activated in the Care Phone.
Link return
Indicates that the Care Phone regained contact with the alarm transmitter.
9
Description of menu selection in the Hand Terminal
9.1
Main menu
Edit alarm code
Means that the Care Phone sends the same alarm code to all programmed alarm
receiver. To send different alarm codes to different alarm receivers, go instead to
the menu >Alarm codes<. The alarm code can contain a maximum of 16 digits.
Speaker volume
Controls the volume of the speaker in steps from 0 to 7, where 0 is the lowest
value and 7 is highest. Here you can control the call volume and the volume of
the audio signals of the Care Phone, for example, before an alarm call.
Quit
At quit, the user is asked do you want to send changes to the Care Phone.
Answer Yes, and all the programmed values are transferred from the hand
terminal to the Care Phone. Answer No, and the programming is terminated
without transferring any values. Note that values not saved in the preset area are
lost if you choose to quit.
Load from preset
Means you can download the preset values, which is then saved in the memory
area. Every time HT is started, the preset values from area 1 are downloaded
automatically.
Programming
Specify the code 1812 to go to the next step in the menu.
9.2
Programming
Load from Phone
All values stored in the Care Phone are read. The reading takes a few seconds.
Load standard values
Erases the memory in the hand terminal and loads the factory preset values.
There is then no information relating to phone numbers, alarm codes and alarm
transmitters.
