2-6
Installing an EN/SC Adapter
Installing a Mini EN/SC Adapter
This section provides two installation procedures—one for installing
a Mini EN/SC Adapter when it is the only SCSI device and the other
when the adapter is part of a SCSI daisy chain.
Installing a Mini EN/SC Adapter as the only device
The Mini EN/SC Adapter has an RJ45 and a BNC port while the Mini
EN/SC 10T Adapter has only the RJ45 port. If you are installing the
Mini EN/SC 10T Adapter, disregard the instructions for Thin Ether-
net cabling.
1
Make sure all devices are turned off.
2
Set the adapter’s SCSI address using the rotary switch on
the bottom of the adapter. See page 2-4 for information.
❖
Note: Each SCSI address must be unique!
❖
3
If your network is not 10BaseT-compliant, the Link Integ-
rity switch must be OFF. (The default is set to ON).
4
Use the provided SCSI cable to connect the adapter to the
Macintosh. Refer to page 2-3 for information.
Plug one end of the cable into the adapter’s SCSI port
and the other end into the Macintosh SCSI port . See Fig-
ure 2-4.
5
Connect the adapter to the Ethernet cable.
Follow the guidelines given below for your cable type:
With 10BaseT cabling
Plug the RJ45 connector on one end of the Ethernet cable
into the adapter’s RJ45 jack and plug the other end into a
10BaseT network hub.
ENSC Ch 2 Page 6 Monday, August 26, 1996 2:50 PM