Artifex LDD100-F Series, Оригинальная инструкция по эксплуатации

Страница: 64 / 72

LDD100 Operating Instructions
64 / 72
18
Continuous Mode 0 - 1
0: Not Continuously
1: Continuously
19 Pulse Width Timer 0 – 250 0 – 150µs (600ns steps)
20 Pulse Separation Timer (High Byte)
200 - 20 000
10µs – 1ms
range multiplier for
pulse separation
21
Pulse Separation Timer (Low Byte)
Following upload of the parameter set, the instrument performs an internal test of the validity
of the input values. If the parameter set is valid, the Byte 0 is returned (no errors). If any
errors have occurred, the Byte 13 is returned followed by the error code.
Table 16: Error Codes
Error Code Meaning
10 Period: value too low (<1)
11 Period: value too high (>
10,000)
12 Pulse duration: value too low (<1)
13 Pulse duration: value too high (>
40,000)
14 Minimum current: value too high (>
4,095)
15 Maximum current: value too high (>
4,095)
16 Number of steps: value too low (<1)
17 Number of steps: value too high (>
1,000)
18 Bias: value too high (>
4,095)
19 Number of cycles: value too high (>
1,000,000,000)
20 Number of cycles: value too low (<1)
21 Mode: value too high (>
2)
22 Continuous mode: value too high (>
1)
23 Pulse
separation
timer: value too high (>
250)
24 Pulse
separation
timer: value too low (<
200)
25 Pulse
separation
timer: value too high (>
20,000)
50 The minimum current is lower than the bias current
51 The maximum current is lower than the bias current
52 Safe operating area: the duty cycle is too high
53 Safe Operating Area: the pulse duration is too high for the maximum. current
54 The minimum current is higher than the maximum current
55 The repetition period must be at least 9µs