Argo Service Manual Engine System
Ontario Drive & Gear Limited. www.odg.com
PH. (519)- 662-2840 FAX (519)- 662-2421
EN-21
2.
Secure the engine to the power pack
frame with 4 bolts, 8 flat washers and 4
nylon locknuts. Refer to the illustrated
parts manual for correct hardware ori-
entation. Torque to specifications.
IMPORTANT
You will notice 8 mounting holes in the block of the engine. It is important that the
correct set of holes is used for clutch offset and belt alignment. Use the holes as
illustrated in Photo EN-40 & 41 below.
3.
Reconnect the power to the electric starter.
Installing the Engine (Briggs Models)
1.
Attach the overhead hoist to both en-
gine hooks and lower the engine into
the vehicle. Photo EN-39
On vehicles manufactured prior to BF12097, RB17665, S12222 & SN12227:
i.
Connect the starter cable at the starter motor.
On vehicles manufactured from BF12097, RB17665, S12222 & SN12227:
i.
Connect the power cable at the starter relay.
Reattach the clip that secures the starter cable at the front of the engine.
EN-39
EN-41
EN-40
