Argo Service Manual Engine System
Ontario Drive & Gear Limited. www.odg.com
PH. (519)- 662-2840 FAX (519)- 662-2421
EN-17
10. Reconnect the fuel line at the carburetor and secure with the hose clamp.
11. Secure the fuel line to the nylon clips at the front of the vehicle.
12. Assemble the lower metal air filter plate to the top of the carburetor. Photo EN-31
13. Assemble the plastic air filter base to the top of the previously installed metal back-
ing plate, Photo EN-32, being sure to reconnect the tube from the base to the air
breather assembly on top of the engine.
EN-31
EN-32
14. Reinstall the air filter element with foam precleaner, and assemble the cover to the
top of the engine.
15. Reconnect the main engine wire harness located between the engine and transmis-
sion.
16. Reconnect the starter cable at the electric starter and cover with the rubber boot.
17. Secure the main engine harness to the nylon clips between the engine and transmis-
sion.
18. Reconnect the ground wire from the negative battery post terminal to the engine.
19. Reconnect the choke cable assembly.
On Conquests manufactured prior to CB14606, slip the assembly back through the body
at the dash and secure with the molded panel nut. It was not required that the choke was
disconnected at the throttle/choke control panel for engine removal, but if it was, you will
need to reattach it at the linkage as well.
On Conquests manufactured from CB14606, reconnect the cable to the throttle/choke
control panel. It was not required that the choke knob was removed at the dash when the
engine was prepared for removal..
