ARG - ABRAHAM REYNOLDS GROUP di Luciano De Pace & C. S.A.S.
Viale Paradiso 19 - I - 10040 RIVAROSSA - (TO) Tel . : +39-011-9700112 - Fax. : +39-011-9700112
E mail : [email protected] Web: www.argweb.eu Web DYNAMO : www.dynamo-jet.it
FLAP SERVO ASSEMBLY
To install the flap servo proceed as follow:
1-Open on the root rib of the wing a 40x20mm rectangular hole as indicated in the picture, aligned with the hole for the servo on the
first internal rib
2 - With a marker pen drawing, following the measures displayed in the picture, the edge of the hole for the servo horn. with a bur
Ø 2.00 open the hole. take care to place the servo horn in the correct position to permit the right movement of the flap.
3 - install the servo, by passing it through the opening of the landing gear, and fixing it with the screw included with the servo.
4 - Prepare a push rod with axle spacing 72.0 mm using a uniball (Item 42) + aluminum rod L = 40.0 mm (Item 40) + (Item 38) rod
M 3.
5 - Mount on the uniball No. 2 horns (Item 21) by having care to hone the terminal bonding area of the rod and tighten the whole
package
6 - Mount the push rod on the servo horn and place the control horn with at 10 mm from the rotation slot open with a bur Ø 2.00 two
slots of an appropriate length.
7 - Prepare the adhesive EP30 with filler and fill the slots previously obtained by inserting the group control horn / uniball and wait
to dryness occurred taking care to position the axis of rotation parallel to the axis of rotation of the mobile part
WIRING WING ASSEMBLY
Is possible buy the pre-cabled kit (Item 62) (Optional), or in alternative made the wires with all connectors by yourself. On the root
rib of fuselage and of the wing you can find the hole for mounting the connectors.
