ARG - ABRAHAM REYNOLDS GROUP di Luciano De Pace & C. S.A.S.
Viale Paradiso 19 - I - 10040 RIVAROSSA - (TO) Tel . : +39-011-9700112 - Fax. : +39-011-9700112
E mail : [email protected] Web: www.argweb.eu Web DYNAMO : www.dynamo-jet.it
JOIN WING / FUSELAGE
To install the screws for joining the wings proceed as follows:
1 - Drill a hole in the Root rib with a 5.5 mm diameter hole, on both wings.
2 - Insert the main joiner (Item11) in the fuselage.
3 - Insert both wings until they are perfectly juxtaposed to the fuselage and the pivot fit perfectly in their seats.
4 - Mark the location of the holes .
5 - Remove the wings and drill with a Ø 5.5 mm the fuselage in the two previous references.
6 - Insert the two M5 blind nuts (Item 30) and glue them with epoxy EP30 and wait until drying.
7 - Put the wings and using the two supplied M5 allen-screw (item 29) and the two steel washers (item 35) fasten until the wings
touch the fuselage.
UAT AND MAIN TANK ASSEMBLY
1 - Assembly the UAT(item 15) and the tank 1.6 lt. (Item 14) realizing the various holes and inserting the fittings supply .
2 - Using the Tygon tube (Item43) achieve the necessary connections according to your fuel system / type of turbine.
3 - Insert the UAT into the appropriate area on the back plate and secure it with two band.
4 - Insert in the half-rib (Item16) for blocking the main tank no. 3 blind Nut M3 nuts (Item 33).
5 - Glue in the first place (for the 2,5 lt use the second seat), with epoxy resin EP5, the main tank support (Item 1).
6 - Prepare a hole for the passage of the overflow pipe at one of the air intake.
7 - Place the tank and secure it with the half-rib and by two bands.
CANOPY ASSEMBLY
To assembly the canopy proceed as follows:
1 - Remove part of material of canopy as shown in the images using a Dremel with a cutting disc and finish
the edges with sandpaper.
2 - Insert at the center of the canopy a carbon tube Ø 8.00 mm by drilling a hole and glue it with epoxy EP30
leaving protrude about 15 mm.
3 - Make a hole in the edge of the fuselage perfectly matching the tube of Ø 8.00mm.
4 - Place the canopy on the fuselage and drill about 14 mm from front end of canopy a hole Ø 3.00 until
pierce also the underlying part.
5 - Remove the canopy and realize a counter hole of 3.2 mm for the passage of the head of the allen-screw
M3 (item 32).
6 - Glue into the hole of the fuselage a blind nut M3 (Item
33) and wait to dryness.
7 - Place the canopy into position and lock it with the allen-screw M3 and verifying the correct coupling.
8 - Glue the blocks in L on the edge of the canopy with epoxy type EP5, about half 'of the length of the fuselage.
9 - Using a dremel to open two slots some millimeter longer than 'L' blocks, on the fuselage edge, at the same position where you
glued the Blocks on the canopy
