ARG - ABRAHAM REYNOLDS GROUP di Luciano De Pace & C. S.A.S.
Viale Paradiso 19 - I - 10040 RIVAROSSA - (TO) Tel . : +39-011-9700112 - Fax. : +39-011-9700112
E mail : [email protected] Web: www.argweb.eu Web DYNAMO : www.dynamo-jet.it
TURBINE COVER ASSEMBLY
To install the turbine cover, proceed as follows:
1 - Trim the turbine cover as you can see in the picture, take care to leave the way clear for the turbine cone.
2 - Glue with EP5 two blocks of plywood on the inside of the cover.
3 - Realize No. 3 rungs with a carbon tube Ø 2,00 as shown and gluing them securely at the cover using a base in
balsa and epoxy resin with filler EP30.
4 - Mark at the pins position on the fuselage and make No. 3 holes Ø 2.00 mm.
5 - Paste No.3 plywood blocks thickness 3 mm inside the fuselage at correspondence of the holes.
6 - Secure the cover with No. 2 self-tapping screws Ø 2.2 x 10 mm (Item 34).
INTAKE
To realize the air intakes proceed as follows:
1 - Drawing the cutting profiles as shown in the picture.
2 - Using a Dremel with a cutting disc remove the part drawn and finish with sandpaper.
RIB FOR SUPPORT ELECTRONIC PLATE ASSEMBLY
To install the rib proceed as follows:
1 - Bonding with epoxy EP5 the small support plate (Item6) to the rib (Item 5) .
2 - Fix into the 4 holes No. 4 blind nut M3 (Item 33).
3 - Paste the rib to the fuselage using epoxy resin with filler EP 30 after welding in place with super glue CA.
The correct positioning is obtained with the two electronic plate provided Item 3 - 4.
