AILERON SERVOS ASSEMBLY
To install the aileron servo proceed as follow:
1 - Using the template (Items 25) drawing the edge for open the hole for mount the servo
2 - Using a Dremel with cutting disc open the hole and finish the edge with sand paper
3 - Install the servo Graupner DS806 BBMG on the servo mount (Item 19). In case of use different servo verify dimensional
compatibility with the servo mount supplied, use only servo with 19mm maximum thickness.
4 - Place the servo mount with servo on the support plate and mark the bonding area.
5 - finish the bonding area with sand paper.
6 - Glue the servo mount in place using epoxy type EP30 taking care to position the plane of the rod command perpendicular to the
axis of rotation of the mobile part.
7 - When dry, remove the servo and the protective film and replace the servo and secure it using the screws included with the servo.
8 - Secure the cover(Item 17) with No. 4 self-tapping screws fastening (Item 34).
9 - Prepare a push rod with axle spacing 82.0 mm using a uniball (Item 42) + aluminum rod L = 50.0 mm (Item 40) + (Item 38) rod
M 3
10 - Mount on the uniball No. 2 horns (Item 21) by having care to hone the terminal bonding area of the rod and tighten the whole
package.
11- Mount the push rod on the servo horn and place the control horn with at 10 mm from the rotation slot open with a bur Ø 2.00 two
slots of an appropriate length.
12 - Prepare the adhesive EP30 with filler and fill the slots previously obtained by inserting the group control horn / uniball and wait
to dryness occurred taking care to position the axis of rotation parallel to the axis of rotation of rotation of the mobile part
ARG - ABRAHAM REYNOLDS GROUP di Luciano De Pace & C. S.A.S.
Viale Paradiso 19 - I - 10040 RIVAROSSA - (TO) Tel . : +39-011-9700112 - Fax. : +39-011-9700112
E mail : [email protected] Web: www.argweb.eu Web DYNAMO : www.dynamo-jet.it
