ARG - ABRAHAM REYNOLDS GROUP di Luciano De Pace & C. S.A.S.
Viale Paradiso 19 - I - 10040 RIVAROSSA - (TO) Tel . : +39-011-9700112 - Fax. : +39-011-9700112
E mail : [email protected] Web: www.argweb.eu Web DYNAMO : www.dynamo-jet.it
STABILIZER ASSEMBLY
For assembly the two stabilizer proceed as follows:
1 - Using the template provided (Item 26) trace the outline on the bottom surface for headquarters of the servo control.
2 - Using a Dremel with a cutting disc remove the part drawn and finish with sandpaper.
3 - Install the servo Graupner DS3288 model BBMG in the door servo fiber provided Item 20. Interposing a film. In case of use
different servo verify dimensional compatibility with the servo mount supplied, use a maximum thickness servo of 11 mm.
4 - Place the Servo mount on the installed plate in the Stabilizer and mark the bonding area.
5 - Hone the bonded area of the servo mount.
6 - Glue the servo mount in place using epoxy type EP30 taking care to position the tail plane of the rod command perpendicular to
the axis of rotation of the mobile part.
7 - When dry, remove the servo and the protective film, replace the servo and secure it using the screws included with the servo.
9 - Secure the cover (Item 18) with No. 4 self-tapping screws fastening (Item 34)
10 - Prepare a push rod with axle spacing 70.0 mm using a uniball Pos 42 + aluminum rod L = 40.0 mm
Item 41 + Item 38 M 3 .
11 - Mount on the uniball No. 2 horns (item 21) having care to hone the terminal bonding area of the rod and tighten the whole
package.
12 - Mount the push rod on the servo horn and place the control horn with at 10 mm from the rotation slot open with a bur Ø 2.00
two slots of an appropriate length.
13 - Prepare the adhesive EP30 with filler and fill the slots previously obtained by inserting the group control horn / uniball and
wait to dryness occurred taking care to position the axis of rotation parallel to the axis of rotation of mobile part.
14 - Create a rectangular open on the root rib of the tail plane with the size of the male plug cable Power
15 - Glue the connector with EP 5 leaving protrude about 3/4 mm.
