Areca ARC-5030 Series, Руководство пользователя

Страница: 42 / 187

CONFIGURATION METHOD
42
3.2 VT100 terminal (Using the controller’s
serial port)
The serial port on the controller’s back panel can be used in VT100
mode. The provided interface cable converts the RS232 signal of
the 10-pin header connector on the RAID subsystem into a 9-pin
D-Sub male connector. The firmware-based terminal array manage -
ment interface can access the array through this RS-232 port. You
can attach a VT-100 compatible terminal or a PC running a VT-100
terminal emulation program to the serial port for accessing the
text-based Setup Menu.
3.2.1 RAID Subsystem RS-232C Port Pin Assign-
ment
To ensure proper communications between the RAID subsystem
and the VT-100 Terminal Emulation, Please configure the VT100
terminal emulation settings to the values shown below:
Terminal requirment
Connection Null-modem cable
Baud Rate 115,200
Data bits 8
Stop 1
Flow Control None
Panel LED Normal Status Problem Indication
Power LED Bright Green This LED does not light up
after power switched on
Busy LED Blink yellow during host comput-
er accessing the RAID subsys-
tem
LED never flickers
Fault LED This LED never light up The LED light up: “RED”,
when disk drive fail
For additional information on using the LCD panel and keypad to
configure the RAID controller see ‘‘LCD Configuration” on Chapter
4.