Areca ARC-5030 Series, Руководство пользователя

Страница: 37 / 187

HARDWARE INSTALLATION
37
LED Normal Status Problem Indication
Power LED
(LCD panel)
Bright Green This LED does not light up after
power switched on
BUSY LED
(LCD panel)
Blink yellow during host
computer accessing the
RAID subsystem
LED never flickers
FAULT LED
(LCD panel)
LED never light up This LED light up: “Red”, when the
disk drive fail
Disk Activity
LED
(LCD panel)
This LED blinks during
hard drive read and write
activity
Voltage LED
(LCD panel)
This LED will remain on
green when the power
is on
This LED will blink red if there is a
voltage error
Themperature
LED
(LCD panel)
This LED will remain on
green when the power
is on
This LED will blink red if there is a
fan problem
Fan LED
(LCD panel)
This LED will remain on
green when the power
is on
This LED will blink red if the internal
temperature rises above the Spec
setting
Method 2: Serial Port Connection
The RAID subsystem can be configured via a VT-100 compatible
terminal or a PC running a VT-100 terminal emulation program.
The provided interface cable converts the RS232 signal of the
10-pin header connector on the RAID subsystem into a 9-pin D-
Sub male connector or the system board, 10-pin header COM2
connector You can attach a serial (Character-Based) terminal or
server com port to the RAID subsystem for access to the text-
based Setup Menu, note the following:
1. Connect a serial terminal to the port labelled COM1.
2. Connect the Host system serial port to the port labelled
COM1.
Method 3: Lan Port Connection
The controller has embedded the TCP/IP & Web Browser-based
RAID manager in the firmware. User can remote manage the
RAID system without adding any user specific software (platform
independent) via standard web browsers directly connected to the
10/100 Ethernet RJ45 LAN port.