19
7. Inspect the handlebar tube for cracks, wear, or
unusual bends.
8. Inspect the handlebar grips for damage or wear.
INSTALLING (Models Without
Electronic Power Steering)
1. Place the steering post into position; then secure the
lower bearing flange to the frame with two cap
screws. Tighten to 20 ft-lb.
AL600D
2. Place the upper steering post housing into position
on the steering post and secure the housings and
plate to the frame with two cap screws. Tighten to 20
ft-lb.
3. Install the tie rods and secure with the slotted nuts.
Tighten to 30 ft-lb; then install new cotter pins.
NOTE: If the slots do not align with the holes in the
tie rod ends, tighten the nuts just enough to allow
installation of the cotter pins.
AF778D
4. Install the handlebar and secure with the handlebar
caps. Tighten the screws to 25 ft-lb.
5. Install the shock absorber and tighten to 50 ft-lb.
6. Install the handlebar cap; then install the console and
gauge.
INSTALLING (Electronic Power
Steering Models)
1. Place the lower steering post into position; then
secure the lower bearing flange to the frame with two
cap screws. Tighten to 20 ft-lb.
AL600D
2. Making sure the double spline is aligned to the slot in
the lower coupler, install the EPS output shaft into
the lower coupler; then install the four caps screws
securing the EPS housing to the frame. Tighten to 35
ft-lb.
EPS008A
EPS007
3. Install the tie rods and secure with the slotted nuts.
Tighten to 30 ft-lb; then install new cotter pins.
NOTE: If the slots do not align with the holes in the
tie rod ends, tighten the nuts just enough to allow
installation of the cotter pins.
Содержание 2016 Alterra 500
Страница 1: ...www arcticcat com SERVICE MANUAL www arcticcat com ...
Страница 170: ...169 NOTES ...