Arctic Cat 2016 Alterra 500, Руководство по обслуживанию

Страница: 19 / 171

18

NOTE: For models not equipped with electronic
power steering, proceed to step 13.
7. Remove the left front shock absorber; then remove
the cap screws and nuts from the steering post to the
EPS couplers.
EPS005A
8. Pull upward on the steering post to disengage the
upper coupler from the EPS assembly.
9. Disconnect the 2-pin and 8-pin connectors from the
top of the EPS housing.
EPS007A
10. Remove four cap screws securing the EPS housing to
the frame; then lift the assembly upward sufficiently
to disengage the lower coupler and remove from the
left side.
11. Remove the cotter pins and slotted nuts from the
inner and outer tie rod ends; then remove the tie rods
from the steering post arm and the left-side and
right-side steering knuckles.
AF778D
KX039
12. Remove two cap screws securing the lower steering
post bearing flange to the frame; then remove the
steering post.
AL600D
CLEANING AND INSPECTING
1. Clean and inspect the pivot area for wear. Apply a
low-temperature grease to the ends.
2. Inspect the tie rods for damaged threads or wear.
3. Inspect the tie rods for cracks or unusual bends.
4. Inspect all welded areas for cracks or deterioration.
5. Inspect the steering post and steering-post brackets
for cracks, bends, or wear.
6. Inspect the bearing halves, bearing caps, and bearing
housings for cracks or wear.
CAUTION
Do not attempt to disassemble the EPS assembly as
there are no serviceable components within the assem-
bly and damage will occur voiding the EPS warranty.
! WARNING
Always wear safety glasses when using compressed
air.