Arctic Cat 2016 Alterra 500, Руководство по обслуживанию

Страница: 138 / 171

137
High: A high voltage condition has been detected
Low: A low voltage condition has been detected
Intermittent: An intermittent circuit condition has been detected
Open: An open circuit condition has been detected * After correcting the condition, cycle the key switch
On-Off-On
**After correcting the condition, cycle the key switch
On-Off-On, start the engine, then cycle the key switch
On-Off-On.
P0615 Starter Relay Circuit Start switch/button, starter relay, gearswitch or interconnect
harness erratic or intermittent Correct condition*
P0616 Starter Relay Circuit Low Start switch/button, starter relay or interconnect harness
intermittent or shorted to chassis ground Correct condition*
P0617 Starter Relay Circuit High Start switch/button, starter relay or interconnect harness
intermittent or shorted to battery power Correct condition*
P0630 VIN Not Programmed or Incompatible Verify the LCD gauge and ECM part numbers are correct for the
vehicle model number and VIN Correct gauge and ECM
VIN compatibility issue*
P0642 Sensor Power Circuit Low One or more of the sensors defective or shorted to chassis ground Correct condition*
P0643 Sensor Power Circuit High One or more of the sensors defective or shorted to battery power Correct condition*
P2300 Rear Ignition Coil Primary Circuit
Low/SG/Open Coil or interconnect harness open or shorted to chassis ground Correct condition**
P2301 Rear Ignition Coil Primary Circuit High Coil or interconnect harness shorted to battery power Correct condition**
P2303 Front Ignition Coil Primary Circuit
Low/Open Coil or interconnect harness open or shorted to chassis ground Correct condition**
P2304 Front Ignition Coil Primary Circuit High Coil or interconnect harness shorted to battery power Correct condition**
P2531 Ignition Switch Circuit Low Battery charge condition low or the regulator/rectifier output low Correct condition*
P2532 Ignition Switch Circuit High Battery cable connections are loose or the regulator/rectifier output
high Correct condition*
U0155 LCD Gauge to EFI ECM CAN
Communication Lost Gauge CAN circuit or interconnect harness intermittent or has
failed Correct condition*
U1000 Vehicle Not Registered or Invalid PIN
Entered An invalid registration PIN has been entered Enter the correct
registration PIN*
U1001 Vehicle Not Registered and Vehicle
Limits Enabled An invalid registration PIN has been entered Enter the correct
registration PIN*
FUEL
OFF Tilt Sensor Activation Code Sensor has been activated Restore the vehicle
chassis to an upright
position*
Code Fault Description Possible Cause Fault Recovery Method