29
29
out which code works with your device. In the example screen, you see the code V009. If this code does not
work when doing the
Test: channel select
, advance it to the next code and then test to see if that next code
works.
3.
Test channel select:
When you press the
Test channel select
button (highlight test channel select and press
ENTER), the AV 700 will send a signal through the docking pod to the infrared emitter and change the channel
on your tuner (VCR, cable box, or satellite receiver). If the Number of digits parameter is set to three, it will try
to select channel 123. If that parameter is set to 2, it will send the code for channel 12. If your tuner does not
change channels when you click on this test button, try the next code for your device (step 2 above).
4.
Test ON/OFF:
When you click on the Test On/Off button, the AV 700 will send a signal to the infrared emitter
and turn your device on or off. Click this test button again and your device should change from on to off or off to
on. If pressing this button does not turn your device on or off, try the next code for your device (step 2 above).
If none of the codes work, check that the infrared emitter is stuck directly over the infrared sensor on your tuner
device.
Note: In some rare cases the ON/OFF functionality may not work.
5.
Tune channel select:
These four parameters usually do not need to be set. Keep the default values to start
with. See the table below for an explanation of each.
Parameter
Description
Parameter
Description
Key: -/--
Set this to
On
if normally, you have to press this same key on your device’s remote control in order to select a channel.
Number of digits
Set the number of digits that your device can recognize for a channel.
Example: Set to 3 if you need to choose a
channel greater than channel 99.
Key: Enter
Set this to
On
if normally, you have to press the Enter key on your device’s remote control after you enter the channel
number.
Example: If you normally press 1, 3, Enter for channel 13, then you would need to set this parameter to On.
Key Delay
Change the delay between the emission of each digit of a channel. You may need to adjust this if the AV 700 seems
to send only half the digits of a channel or more digits of a channel.
Example: Adjust the key delay and retest channel
select if it sends channel 2 instead of 12 or sends 112 instead of 12.
30
30
8
8
VIDEO – Editing Video Files
VIDEO – Editing Video Files
Video
fi
les recorded by the AV 700 can be modi
fi
ed by deleting the sections you do not wish included. The editing
you can do is either cropping or cutting of particular segments of the video
fi
le. You will mark a segment of your
video
fi
le, and then you will tell the AV 700 to delete everything except the marked segment (crop) or to delete the
marked segment (cut) from the video
fi
le. These operations can be done multiple times on the same video
fi
le.
Once
fi
nished, you will have the option to save the edit marks with the video or to write a new video
fi
le. If you
save your
fi
le with edit marks, you can always go back and change your edits at another time. The actual video
information is not deleted. On the other hand, you can write a new
fi
le which will only include the video parts that
you speci
fi
ed in the edit session. This
fi
le will be smaller but you can never un-edit it.
Example 1:
You have recorded a music video program and would like to keep one single music presentation.
The rest of the television recording you do not care to keep. In this case, you would set a Start mark (a) at the
beginning of the desired segment, and an End mark (b) at the end of the desired segment. You would then
choose Keep selected part action icon which would then delete everything except the designated section.
