44
10.1.12 Working parameters
*
Fig. 128
Set the farming machine job limits.
*
Item
Tank level correction factor
is available only if
Tank level sensor
was selected,
under 9 "Basic settings".
SPRAYING LIMITS
Fig. 129
Fig. 130
• Spraying speed limit
To configure the items on this menu, you must
enable the speed limit:
Limit enabled
Limite disattivato
• Minimum spraying speed
Set the minimum spraying speed:
Delta 80 closes the main valve when the tractor
speed is lower than the set value.
Fig. 131
Fig. 132
• Regulation pressure limit
To configure the items on this menu, you must
enable the pressure limit:
Limit enabled
Limite disattivato
• Minimum regulation pressure
Set the minimum spraying pressure:
Delta 80 blocks the automatic regulation of the
proportional valve when the pressure is lower
than the set value.
Fig. 133
• Flowrate correction factor
When using a paddle flowmeter and the sprayed fluid has a different viscosity than that of water, the
computer could display wrong measurements; to correct them change the flowrate correction factor:
• if at the end of the spraying the tank still contains fluid, reduce the factor;
• if the fluid finishes before the job has ended, increase the factor.
Flowmeters of the ORION series (code 462xxx) are not affected by the viscosity difference of
the fluids: set the value to 1.00.
Fig. 134
• Tank level correction factor
If the sprayed fluid is lighter than water, the device may indicate wrong measurements; to correct this
measurement, edit the sprayed liquid weight, referred to 1 liter of product.
CONTINUES > > >
ADVANCED SETUP
"IMPLEMENT"
