AQUARIUS ULTIMA, Инструкция по эксплуатации

Страница: 3 / 28

3
Warnings
Refer to AS/NZS 3000 WIRING RULES when installing electrical equipment on and around the
cooling towers and HVAC equipment. The power cover is to be removed by Aquarius Technologies
Pty Ltd, an authorized service agent or a licensed electrician only, and must be replaced before the
controller is connected to the power supply. Do not open the controller enclosure except as
required for maintenance purposes. Once maintenance is complete, the enclosure is to be closed
and resealed. If the supply cord is damaged, it shall be replaced by Aquarius Technologies Pty Ltd
or an authorized service agent to avoid a hazard. This appliance is not intended for use by young
children or infirm persons unless they have been adequately supervised by a responsible person to
ensure they can use the appliance safely. Young children should be supervised to ensure they do
not play with the appliance.
This marking indicates that this product should not be disposed of with other household
wastes throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental safe
recycling.
Chemicals used as part of the treatment program may be hazardous. Refer to the Material Safety
Data Sheets provided by your chemical supplier and ensure all personnel involved are aware of
the handling and safety procedures.
It is a requirement to provide protection for accidental spills of chemicals and that includes any
leaks that can develop from pump pressure lines. Please read and understand all safety warnings
on chemical containers before servicing any dosing equipment. Some chemicals will damage
materials used in construction of buildings, particularly roofing. Never assume that the equipment
will not leak, under certain conditions that will occur. It is the responsibility of the installer to ensure
that such events do not create damage that should have been avoided by correct site selection
and the provision of adequate bunding at the time of installation.
Wear as a minimum - safety goggles and gloves when servicing the dosing equipment. Do not mix
concentrated acids and oxidising agents as explosion, and/or toxic and lethal gas may be evolved,
and/or fire result. Keep all chemical containers sealed and free from contamination.
Bleed solenoid and BCD solenoid leads should not be left unattended due to the risk of high
voltage hazards. All solenoids must be connected to their leads before turning the controller ON. It
is a full responsibility of the installer and user to ensure the leads are not exposed to the open air
or water ingress.