AQUARIUS ULTIMA, Инструкция по эксплуатации

Страница: 11 / 28

11
System configuration
The ULTIMA controller has a 7” touch screen and navigation is similar to that of any smart phone,
PC monitor, GPRS navigator or other modern device. Operating the controller is done by
touching the screen and navigating using your finger. The ULTIMA controller screen is covered
with a protective film.
CAUTION: Do not operate the controller with dirty or wet fingers. Do not touch the controller
screen with metal or sharp object. Always close the screen flap cover down on completion.
All Aquarius controllers come loaded with preset default values for all of the treatment program
parameters. On start up the controller will operate according to those defaults. However, every
application should have a planned treatment program developed. Decisions should be made on
what values are most appropriate for ORP, pH, TDS/ Conductivity, Inhibitor, Secondary Biocide
and Dispersant dosing requirements.
Once the customized program has been determined, it may be set in the Aquarius controller, as
described in the following sections.
Turning the ULTIMA controller ON
When you plug the controller into 240 VAC supply it turns ON. It takes about 30 seconds for the
controller to open its program. During this time AQUARIUS animation logo will appear on the
screen.
CAUTION:
All provided solenoid cables are wired to 240V electricity source and must not be left unattended
when turning the controller ON
- Do not turn the controller ON until the bleed solenoid cable is wired to a proper solenoid
- Do not turn the controller ON until BCD solenoid cable is wired to a proper solenoid or it is
unplugged from the controller (if BCD solenoid cable is included)
When the program is fully loaded the front lock screen will appear. (Picture 4) To start using the
controller, press the UNLOCK.
Picture 4. UNLOCK Screen