Simpool Timer Model
INSTRUCTION AND MAINTENANCE MANUAL
Programmable digital peristaltic pump ENGLISH
ADSP7000722 rev. 1.0 23/02/2017
42/64
Fig. 6 Dosage according to the inhibiting signal
If the dosage has been set to start when the recirculation pump starts but the ignition is not recognised within the
programmable time frame, or the recirculation pump is turned off before the dosage completion, the display will
show an alarm (see Inhibiting Signal Alarm in the
Alarm
section) signalling the incomplete dosage up to the next
daily dosage.
If the inhibiting signal is disabled the pump will dose according to the scheduled time and length.
MENU
When the pump is turned on, regardless of the status of the switch, for a second the display shows the firmware
version with the following format “
rx.y”
. It then displays the first entry of the Initial Menu.
You can browse the whole Menu both when the switch is ON and when it is OFF.
The Menu consists of the following submenus:
▪
Initial Menu
, which allows to display the status of the pump;
▪
User Menu
, which allows to change the main operating parameters;
▪
Programming Menu
,
which allows to set all of the operating parameters and to display the statistics: this
menu can be accessed only by entering a password;
To browse through the Menus refer to
- Menu Map.
Initial Menu
The first entry of the Initial menu displays one of the following pages, depending on the status of the switch and the
pump:
(*) example value corresponding to the time: hours and minutes visible in turns;
(**) example value corresponding to the dosage time countdown;
noS (Signal not active):
displayed if the inhibiting signal, which is linked to the pool water recirculation pump, is
not active;
Stb (Signal in Stabilization):
displayed if the inhibiting signal, which is linked to the pool water circulation pump, is
active but waiting to be stabilized;
Time:
when the dosage and the inhibiting signal are off the hours and the minutes are visible in turns;
Alr (Alarm entry):
if there are one or several active alarms, with the switch set to ON, every page of the Initial
Menu will be alternated to the entry that reports the signal with the top priority.
(see Alarm section).
Dosage Countdown:
when the dosage is in progress the remaining time is displayed and expressed in minutes
and the last minute is expressed in seconds.
