Adjusting the wall circumference
9
5.
Putting up the wall
IMPORTANT NOTE:
If you use a skimmer, you should consider
putting the pre-punched slots not too far
from the planned location of the filter. If you
don’t use a skimmer, the pre-punched holes
must be covered with heavy fabric tape. It
prevents the lining for being cut.
04
GENERAL INSTRUCTIONS - ROUND POOLS
Round pool footprint - All sizes
Size
Uprights
Rails
Radius of rails
Wall perimeter
15’ 18’ 21’ 24’ 27’ 30’ 33’
10 12 14 16 18 20 22
20 24 28 32 36 40 44
7’6’’ 9’0’’ 10’6’’ 12’0’’ 13’6’’ 15’0’’ 16’6’’
566 680 793 906 1019 1132 1245
ASSEMBLING
THE POOL WALL
8
9
Bring the following items into the middle of the pool foundation before you start
uncoiling the pool wall: plywood, some extra sand or fine dirt to make the cove,
the liner and a ladder to climb out after the wall is assembled.
Make sure the skimmer and water return holes are located where you need them
to be. The skimmer and water return holes are positioned towards the end of the
wall.
Unpackage the coiled pool wall and stand it on the plywood at the place close to
where you need to install skimmers. (image 8)
Start uncoiling the wall, guiding the bottom edge into the curved bottom rail. The
starting end of the wall must be positioned in the centre of a bottom plate and
the skimmer and return holes should be positioned where the pump and filter will
be. (image 9)
Set lengths of stabilizer onto the top ledge of the wall as you uncoil it.
7
SECTION
Содержание Contempra Round
Страница 1: ...GENERAL INSTRUCTIONS for regular installation...
Страница 24: ......