Aqua Leader Contempra Round, Общее руководство по инструкции

Страница: 13 / 24

04
SECTION
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING
THE POOL WALL
7.
Making the cove
You can now spread approximately 2” (5cm) of screened earth or mason’s sand
all around the inside of the pool wall. Build a cove of 3” (7,5cm) high, and not
less, of well packed screened earth or mason’s sand. (image 16)
Water the sand to compact it and use a trowel to spread it evenly.
DO NOT USE THIN SAND. GRASSTURF OR ANY OTHER MATERIAL SO CALLED
“POOL BASE” THAT CAN CAUSE DAMAGES TO YOUR POOL. THE LINER COULD
EVENTUALLY RUPTURE.
The cove is very important. THE MANUFACTURER WILL NOT BE RESPONSIBLE
FOR DAMAGES CAUSED BY OMISSION OF THIS STEP.
If you are using Styrofoam cove pieces instead of sand, insert them in the bot-
tom rail and refer to the installation instructions that are provided with them.
8.
Vinyl liner installation
A vacuum cleaner can later be used to remove the air from between the liner
and the wall (image 17). This technique enables you to remove folds on the
liner. However the following precautions should be taken:
Do not use an industrial vacuum cleaner which could be too
powerful.
Tape the end of the vacuum hose before inserting it into the wall
so as not damage the liner.
Insert the nozzle until it is about 4” (10cm) above the cove (insert
through the water return outlet or the skimmer depending on
the diameter of your hose.) Make sure you will be able to remove
the hose later on.
Tape the hose to the wall.
+
+
+
+
12
8’’- 12’’
3’’- 6’’
16
17