Aqua Leader Contempra Round, Общее руководство по инструкции

Страница: 9 / 24

Concrete patio stones may be placed at the base of each upright of your pool.
Each bottom plate will show the location for a patio stone. Make a mark in the
ground at each base plate.
Remove the bottom rails and bottom plates and lay out the patio stones around
the circle where the bottom plates were.
The patio stones must be sunk into the ground so the tops are flush with the
soil around them (image 4). Use the carpenter’s level to make sure the patio
stones are perfectly level and flush with the ground. Use either the carpenter’s
level and a 2-by-4 (5cm x 10cm) wood plank, or the optical level between patio
stones to make sure the stones are level with each other. (image 5)
Do not install blocks or rails on loose sifted soil or sand. There must be no space
between the ground and the bottom of the rails. All patio blocks must be flush
with the ground, solid and level with each other in all directions
Patio stones installation (OPTIONAL)
4.
Wall Channels and post base assembly
Place all the wall channels and the post bases over the traced circle.
Insert the bottom wall channel on both sides of the post bases and allow a space
of 2” (60 mm) between each wall channels ends. Make complete circle using all
the bottom channels. (image 6)
Check the roundness of your circle, by measuring the diameter across in several
locations. Since the bottom rails do not automatically form a true circle, DO NOT
SKIP THIS STEP! Otherwise you might end up with a slightly oval shape, which
can cause problems later on. (image 7)
03
SECTION
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING
THE POOL BASE
8
6
5
4
3.
Levelling your pool site