Diagnostics
Document No. D113-015
Page 60 of 77
Revision 1.9
Relay Message Inhibit
Flagged when Class 2 HART relay messages have been disabled in the
configuration.
Burst Mode Active
Flagged if the field device is operating in burst mode.
Parity Error
Flagged if the field device received a message with a parity error
Overrun Error
Flagged if the field device receive buffer is overrun.
Framing Error
Flagged if the field device receives a message with an invalid stop delimiter.
Checksum Error
Flagged if the field device receives a message with an invalid checksum.
Rx Buffer Overflow
Flagged if the field device receives a message too long for the receive buffer.
Device Malfunction
Flagged if the field device has detected an error or suffered some hardware
failure.
Config Changed
Flagged if an operation resulted in the configuration changing.
Cold Start
Flagged if the field device has experienced a power failure or reset.
Output Current Fixed
Flagged if the loop current is set at a fixed value and is not responding to
process variations
Analog Output Saturated
Flagged if the Loop Current has reached its upper or lower limit
Variable Out of Limits
Flagged if a variable other than the PV is beyond its operating limits.
PV Out of Limits
Flagged if the PV is beyond its operating limits.
Command Error
An enumerated error in response to the last command issued.
Table 5.9 - Channel Status Parameters – Device Status
The Device Configuration tab provides the facility to display and modify common HART
parameters in the field device.
Figure 5.13 - Channel Status – Device Configuration
