MRT Models
17
Anthony Lifgtates, Inc.
800-482-0003
www.anthonyliftgates.com
5. Make sure the corner posts are flush with the rear sill.
If they are not flush, add spacers, as shown in the
illustration.
45"
Spacer (thickness
as required)
(61" on above bed
height models)
A-1008
Bed Height
Rear sill and spacer
must be flush.
Add spacers to make the corner posts fl ush with the rear sill.
3/16 x 2" long
welds every 12"
on both sides of the
rear corner post, on
each side of truck
A-1009
Rear sill and
spacer must be flush.
Weld spacers to the corner post using 3/16 x 2” long welds
every 12”.
Tip: An alternative to one long spacer is using 3” long
plates spaced 9” apart. Make sure the last plate is
located 45” or 61” above the bed height, depending
on the liftgate model being installed.
4.7 Prior To Installation
1. Place the truck on a flat, level surface. The rear
surface of the truck or trailer must be straight and
square.
2. Block the wheels to prevent possible truck movement
during liftgate installation.
3. Remove the banding securing the power unit
enclosure.
The power unit box should contain a package containing
decals and manuals.
4. Remove the banding securing the battery box.