MRT Models
25
Anthony Lifgtates, Inc.
800-482-0003
www.anthonyliftgates.com
19. Route the other end of the battery cable from the
liftgate battery box to the vehicle’s battery box.
20. Install 200 Amp Circuit Breaker (1) somewhere near
or in the truck battery compartment (within
24 inches), where it is easy to reach to be reset.
21. Connect the battery cable from the liftgate battery
box to circuit breaker terminal (H).
Note
: An optional battery separator can also be installed
at this time. The following steps cover the
installation of the battery separator. If this option is
used, omit the preceding step.
22. Connect the battery cable from the liftgate battery
box to terminal (F) on the battery separator or
terminal (H) of the circuit breaker.
23. Connect battery separator terminal (G) to circuit
breaker terminal (H).
24. Connect circuit breaker terminal (I) to the batteries
positive (+) post (J).
25. Connect a #14 gauge wire between chassis ground
and the battery separator ground terminal. This may
momentarily activate the battery separator. This is
normal. For additional wiring options, refer to “7.2.6
Battery Separator” on page 44.
26. Make sure all hoses and wires are securely attached
to the frame of the vehicle. Make sure that no wire
or hose will be damaged by rubbing against another
part.
