ANTEK AIR MAGNA 150, Инструкция по установке и обслуживанию

Страница: 9 / 53

9
PIPE CONNECTIONS
General
Pipe installation must be carried out in accordance with current norms and directives. The heat pump
can operate up to a return temperature of about 58°C and an outgoing temperature of about 70°C from
the heat pump. The compressor produces up to 65°C, the rest is obtained using additional heating.
The other heat pumps has a max return temperature of approximately 50 °C and an outgoing max tem-
perature from the heat pump of approximately 60 °C.
Since the AIR MAGNA 150 is not fitted with shut-off valves, these must be fitted outside of the heat
pump to make future servicing easier.
During assembly the pipes for the heat medium and water heater and possibly hot water circulation are
routed backwards. The distance between AIR MAGNA 150 and the wall ought to be 50 mm.
Copper pipe connections
According to their practical situation, users can choose the place on mainframe ( left or right ) for the out
of connecting copper pipe.
The size of the outlet for connecting copper pipe can be adjusted by the fixing board.
Copper tuble size
Modell/Size 6 8 10 12 16
Gastube 1/2“ 5/8“ 5/8“ 3/4“ 3/4“
Liquidtube 1/4“ 3/8“ 3/8“ 1/2“ 1/2“
NOTE! Defrosting temperature sensor and outside temperature sensor should be connected to outdoor
unit through the connecting outlet of mainframe and outdoor unit.
NOTE! The pipe system needs to be flushed out before the heat pump is connected so that debris can-
not damage component parts.